If none are found within that distance, Circuit Builder will not stretch this wire. It tells Circuit Builder to skip over two vertical wires when trying to connect to the vertical bus and to search up to 200 times the trap distance for a vertical wire to connect to. Change the MISC1 value to _WIRESKIP=2 _MAXTRAPCOUNT=200, making sure to enter the semi-colon character between the values.Enter ATTEDIT and select the bottom WCON marker block.If _MAXTRAPCOUNT is not defined or is zero, the search is across the whole extents of the drawing. It is measured in an integer number of wire connection trap distance units. The _MAXTRAPCOUNT limits the relative distance that circuit builder searches to find a wire to connect to. Removing this value directs Circuit Builder to connect to the first vertical wire it finds. The _WIRESKIP value defines the number of wires to skip over when trying to connect to the vertical bus when inserted. Change the MISC1 value to _MAXTRAPCOUNT=200, removing _WIRESKIP=2.See the Marker block attributes topic for a complete list of supported values. MISC1 = _WIRESKIP=2 _MAXTRAPCOUNT=200 - defines any special handling of the marker block.Blocks with the same ORDER value are processed as a group. The blocks are processed low to high starting at 0. The order value can be an integer number or a decimal number. ORDER = 1.02 - indicates the order of processing for the marker block relative to all the other marker blocks in the template.CODE = WCON - maps back to a row in the circuit codes sheet with a function to stretch the end of the underlying wire to try to make a connection.Enter ATTEDIT and select the top WCON marker block.Each one is directly on top of and near the end of one of the wires. You should see three marker blocks, each with a CODE value of WCON. Zoom in on the left-hand side of the template.Enter ON to make all attributes visible.To erase and purge the invisible block, follow these steps: If you accidentally use a command that inserts the invisible WD_M block, either UNDO or erase and purge the WD_M block instance.
It avoids creating a template that contains an extra copy of the AutoCAD Electrical toolset WD_M block. Use standard AutoCAD commands to modify the template and not AutoCAD Electrical toolset commands. See Circuit Builder spreadsheet overview for the location of this file. Open ace_circuit_builder.xls in a spreadsheet software for reference.This template consists of three wires and some marker blocks. Make sure that you have write access to the drawing. Open the copied and renamed circuit template, ace_cb1_FVNR_H_custom.dwg, in AutoCAD.Note: The circuit template name is not critical and does not affect functionality of Circuit Builder.
0 kommentar(er)
